Valor G4 Series Installation And Operating Instructions Manual page 5

2.
Remove the fan.
WARNING
TO AVOID ELECTRIC SHOCK disconnect the
power to the fan before servicing.
The fan is fixed to the its enclosure with pegs.
a) Grab the fan and gently pull it forward. When
you feel that it disengages from its pegs,
rotate the fan forward to get the top out of the
enclosure first, then pull it out.
b) After verifying that the power is off, remove the
two "L" shaped connectors on top of the fan
motor and the ground wire.
Note: Grab the whole connector when
disconnecting—DO NOT pull on the wires!
c) Disconnect the green ground wire from the fan
itself using a 9 mm wrench.
NOTE: If the fan needs to be replaced, make
sure the replacement is fitted with foam pads
and rubber grommets as this allows the fan
to be tight within the enclosure to avoid any
vibration when functioning.
Foam pads (4)
Rubber grommets (4)
3.
Remove the fan control module.
If you need to remove the fan control module, remove
the fan first. The module is on the left hand side of the
fan and it is held in place by a piece of Velcro.
a) Pull the fan out of the enclosure as indicated
in step 2. DO NOT FORGET TO CUT THE
POWER TO THE FAN FIRST!
b) Pull the fan control module out carefully as it
is still connected to the power cord and to the
receiver.
c) Disconnect the power, the fan, and the receiver
connectors to release the module.
Note: Grab the whole connector when
disconnecting—DO NOT pull on the wires!
Fan module to fan connectors
Fan module to receiver connector
4.
Reconnect and reinstall the module and the fan
after servicing.
5.
Reinstall the following components in the firebox in
this order:
a) the fan access panel (12 screws)—see step 1 h
b) the air baffle (6 screws)—see step 1 g
c) the ceramic walls—see fireplace instruction
manual
d) the front log support—see step 1 e
e) the rear log support (3 screws)—see step 1 d
f) the grate, ceramic logs or rocks and window—
see fireplace instruction manual.
5