Table of Contents
Advertisement
Available languages
Available languages
Quick Links
INSTALLATION MANUAL
1495CFK Circulating Fan Kit
Approved for use with Valor fireplace models 1400M only
WARNING
If these instructions are not followed
exactly, a fire or explosion may result
causing property damage, personal
injury or loss of life.
Description of System
The model listed above has been designed to accommo-
date the installation of this air circulation fan.
Operated via the remote control handset and having
variable speed control, the fan is designed to boost the
natural convection through the heater; this may be a
desirable feature dependent on the fireplace location
and room layout.
It is preferable to install the circulating fan before
completing the heater installation, although it may
also be retrofitted at a later date. A junction box and
receptacle for powering accent lighting are supplied
as standard equipmentwith the 1400M fireplace. This
optional 1495CK Circulating Fan Kit is intended to utilize
the same power supply as the accent lighting. Therefore
a separate power supply is not required.
WARNING
Live wiring must terminate within
a junction box. A junction box is
supplied with the fireplace.
Ensure the power for the accent lighting has been in-
stalled before proceeding. Otherwise, see the fireplace's
Installation Manual to set it up.
4009243-01
© 2022, Miles Industries Ltd. All rights reserved.
H6 1400M
NOTE
This kit must be installed or serviced by
a qualified installer, service agency or
gas supplier. These instructions are to
be used in conjunction with the main
installation instructions for the above
listed fireplace models.
Retrofitting the fan after the fireplace installation is com-
pleted will require disconnecting the gas and removing
the burner module and gas train from the fireplace.
The fan is designed to operate on and off automatically
when the burner comes on and off. The fan speed can
be controlled from the remote control handset. There
are four speeds available. The fan, if turned on, will start
approximately 4 minutes after lighting the fireplace and
will continue to run for approximately 10 minutes after
the burner is shut off, and the control valve has rotated
all the way to "OFF". The fan will operate at the speed
last selected by the user.
Electrical Requirements
The fan kit requires a power supply of 120 Volts,
1 phase, 60 Hz. Full load current is less than 1 amp.
WARNING
The power supply must be installed
and grounded in accordance with
local codes, or in the absence of local
codes, with current Canadian Electrical
Code CSA C22.1, or, in the USA the
National Electrical Code ANSI/NFPA70
latest edition.
1
Advertisement
Table of Contents
Related Manuals for Valor H6 1400M
Summary of Contents for Valor H6 1400M
- Page 1 INSTALLATION MANUAL H6 1400M 1495CFK Circulating Fan Kit Approved for use with Valor fireplace models 1400M only NOTE WARNING This kit must be installed or serviced by If these instructions are not followed a qualified installer, service agency or exactly, a fire or explosion may result gas supplier.
- Page 2 Fan Kits Components 2. Remove burner module to access fan location. a. Remove the cover panel surrounding the burner The complete 1495CFK kit contains the following: (4 screws). • Fan assembly, motor unit on mounting plate • Control wire, Fan to V-module •...
- Page 3 Install Fan Into Fireplace 4. If necessary, thread the power cord around the back of the firebox post as indicated. The V-module, power cord and junction box should 5. Plug the power cable into the receptacle—only after already be installed in the firebox as part of the the other connections mentioned earlier are standard accent lighting supplied with the fireplace.
-
Page 4: Regular Operation
Test Fan Operation Regular Operation The fan is normally operated by the remote control sys- The instructions to operate the fan are included in the tem when the fireplace is functioning. To test the opera- Remote Control Operation section of the Installation tion of the fan after the connections have been made, it Manual and the Homeowner’s Manual supplied with the is not necessary to have the fireplace operating. -
Page 5: Wiring Diagram
Wiring Diagram GROUND WIRE SCREWED TO BLOWER 300 mm LENGTH BLOWER BLOWER MOUNTING PLATE JUNCTION BOX WITH RECEPTACLE WITHIN FIREPLACE POWER CORD (SHIPPED WITH FIREPLACE) (SHIPPED WITH ACCENT FIREPLACE) MODEL 1495CFK LIGHTING (SHIPPED CIRCULATING FAN KIT WITH 120 VAC, 60 HZ, LESS THAN 1 AMP FIREPLACE) MANUFACTURED BY MILES INDUSTRIES LTD. -
Page 6: Guide D'installation
GUIDE D’INSTALLATION H6 1400M Ventilateur de circulation d’air 1495CFK Certifié pour usage avec les foyers Valor 1400M seulement NOTE AVERTISSEMENT Ce kit doit être installé et entretenu Si les instructions fournies dans le par un installateur qualifié, une agence présent guide ne sont pas suivies de service certifiée ou un fournisseur... -
Page 7: Contenu Du Kit
Contenu du kit 2. Enlevez le couvercle du brûleur (4 vis). La trousse du ventilateur 1495CFK contient : • Ventilateur, sur la plaque de montage • Câble, ventilateur au module de commande (v-module) • Écrous hex (2) • Serre-fil adhésif •... - Page 8 Installez le ventilateur dans le foyer. 4. Si nécessaire, faites passer le cordon électrique derrière la patte avant de la boîte de foyer tel Le module de commande (V-module), le cordon qu’indiqué. d’alimentation et le boîtier de raccordement devraient 5. Branchez le cordon d’alimentation du ventilateur à être déjà...
-
Page 9: Opération Normale
Vérifiez l’opération du ventilateur Opération normale Normalement le ventilateur fonctionne à l’aide de la té- Les directives d’utilisation du ventilateur sont incluses lécommande lorsque le brûleur est allumé. Pour vérifier dans la section Fonctionnement de la télécommande du les fonctions du ventilateur après l’avoir installé, il n’est Guide d’installation fourni avec le foyer. -
Page 10: Schéma Des Connexions
Schéma des connexions FIL DE MISE À LA TERRE FIXÉ AU VENTILATEUR VENTILATEUR 300 mm LONG PLAQUE DE MONTAGE DU VENTILATEUR BOÎTE DE RACCORDEMENT DANS LE FOYER (FOURNIE AVEC LE FOYER) CORDON MISE À D’ALIMENTATION TERRE (FOURNI AVEC LE FOYER) MODÈLE 1495CFK ÉCLAIRAGE VENTILATEUR DE CIRCULATION D’AIR...