Strong SRT 4935II User Manual page 13

6. Operation
▣ OTA Menu
1. Select a satellite for OTA service
2. Enter the transpondes's information (frequency, symbolrate)by 0~9 buttons.
3. Press RED button to start Scan.
4. If transponder's information is correct, a pop-up window will display to update software.
➍ Channel Selection
▣ If you know the channel number, you can enter it with the NUMERIC buttons and wait
2 seconds until the channel is changed.
▣ You can press OK to display the channel list <Figure 6.1.7>
1. You can use the following buttons to navigate between channels:
➎ Other Functions of the Remote Control
▣ Volume Control
1. While watching a program, press
2. You can press the MUTE button to remove the sound of the program: the mute icon will be
displayed. Press the MUTE button again to turn the sound back on.
▣ Channel Information
1. You can press the INFO button to display the information banner for a few seconds.
2. If you then press the INFO button again, a detailed banner will be displayed.
▣ TV/ RADIO switching
You can press this key to change from a TV channel to a Radio channel or vice versa.
▣ RECALL
Press to return to the previous channel.
[2015.06.15]SRT4935Ⅱ Manual_english+French_NIG_rev1.0.indd 13
▪
: Moves one page up / one page down.
▪
▪ RED: Shows all channels in the current group.
▪ GREEN: Shows all channels sorted alphabetically.
▪ YELLOW: Shows all channels sorted by Transponder.
▪ BLUE: Shows all channels sorted by CAS system.
2. Press OK when the selection bar is positioned on the
desired channel.
Figure 6.1.7
or to control the volume.
: Moves one channel up/ down.
English
13
2015-06-16 오후 2:21:48