Strong SRT 4935II User Manual page 11

6. Operation
r.
(When the DiSEqC Motor parameter is set as 1.2)
If you select "diseqc1.2", "Sat Degree/Antenna Longitude/Antenna Latitude" is not available.
▪ Moter Setup : Setup motor by press OK.
▫ Frequency :
▫ Go to x :
▫ Save :
▫ Recalculate :
(When the DiSEqC Motor parameter is set as USALS)
▪ Sat Degree: Satellite location.
▪ Antenna Longitude: Your longitude at present.
▪ Antenna Latitude: Your latitude at present.
▪ Motor Setup: Press OK
Set the Antenna Longitud/Antenna Latitude, Usals can move dish automatically.
✽ Note: You need to know what LNB you are using to correctly set the L.O.
✽ Note: You need to understand how your receiver is connected to properly set the
[2015.06.15]SRT4935Ⅱ Manual_english+French_NIG_rev1.0.indd 11
Figure 6.1.3
Press button to change TP.
Press OK to open a list you can to to X or go to reference.
to move the dish and press OK to save position.
Press
Press OK to recalculate.
(local oscillator) frequency.
22KHz and DiSEqC.
5. Select the item that you want to edit and set its
parameters as desired. <Motorized Setting>
▪ Frequency: You can select appropriate TP frequency
at which to check for signal.
▪ DiSEqC Motor: Select DiSEqC protocol among OFF/1.2/
USALS as appropriate for your Motor.
▪ Limit Setting : press OK
Save : Move the dish to west or east by pressing
▫
When you are moving to the target place, press OK to
save point.
Goto Reference : Move the dish to the 0 position.
▫
English
.
11
2015-06-16 오후 2:21:47