Xbee - Digi ConnectCore 8X Hardware Reference Manual

XBee

The ConnectCore 8X SBC Express provides an XBee socket to connect a Digi XBee/XBee-PRO module. The XBee socket consist of two 10-pin, 2 mm pitch
connectors (J12 and J13) which follow the standard pinout of the XBee modules:
Description
Output 3.3V power supply line
XBee UART output data line
XBee UART input data line
XBee reset line, connected to
ConnectCore 8X GPIO3_13
XBee request line, connected to
ConnectCore 8X GPIO3_16
The XBee can communicate with the ConnectCore 8X system-on-module in two different ways:
Schematic J12
signal name pin XBee Standard pin
XBEE_VCC 1 1 - VCC
XBEE_UART_RX 2 2 - DOUT
XBEE_UART_TX 3 3 - DIN/CONFIG_N
- 4 4 - D08
XBEE_RESET 5 5 - RESET_N
- 6 6 - PWM0/RSSI
- 7 7 - Reserved
- 8 8 - Reserved
XBEE_SLEEP_RQ 9 9 - DTR_N/SLEEP_
RQ/DI8
GND 10 10 - GND
J13 Schematic signal
pin name
1
ADC0/DIO0 - 20
2
AD1/DIO1 - 19
3
AD2/DIO2 - 18
4
AD3/DIO3 - 17
5 XBEE_UART_RTC
RTS_N/DIO6 - 16
6
AD5/DIO5 - 15
7
VREF - 14
8
ON/SLEEP_N - 13 XBEE_ON/SLP_N
9 XBEE_UART_CTS
CTS_N/DIO7 - 12
10 -
AD4/DIO4 - 11
Description
-
-
-
-
XBee UART
clear to send
line
-
-
XBee status
line,
connected to
ConnectCore
8X GPIO3_14
XBee UART
request to
send line