Adjust The Parking Linkage - Taylor-Dunn MB-238-00 Operation, T Roubleshooting And Replacement Parts Manual

Maintenance, Service, and Repair

ADJUST THE PARKING LINKAGE

6. Release the park brake.
7. Disconnect the linkage to the park brake handle by
removing the clevis pin at the handle.
8. While pulling on the cross-shaft to take up all of the
cable slack, adjust the center linkage so that the
cross-shaft tab is vertical.
9. Adjust the side linkage so that the clevis pin can be
easily inserted into the handle tab.
10. Install new cotter pins and tighten all jam nuts.
11. Set the park brake.
12. Reconnect the main positive and negative cables
at the batteries.
13. Remove blocks from behind the wheels.
14. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Brakes
NOTE: If there is no adjustment left
in the linkages, then the Brake Arm
Extension must be rotated to
engage the next hole in the arm.
Page 6