Tilt The Projector Platform; Cable Management - StarTech.com ADJPROJCART User Manual

Loosen and remove the Knob on each one of the M6 x 50
3.
mm Button Head Screws.
Remove the two M6 x 50 mm Button Head Screws from the
4.
two holes located in the outer portion of the Support Pole.
Adjust the inner portion of the Support Pole to the desired
5.
height setting.
Insert two M6 x 50 mm Button Head Screws through the
6.
two holes located in the outer portion of the Support Pole.
Thread one Knob onto each one of the M6 x 50 mm Button
7.
Head Screws and hand tighten.
Note: Do not overtighten the Knobs.

Tilt the Projector Platform

Loosen the Knob under the Projector Platform while
1.
supporting the weight of the Projector and the Projector
Platform.
Tilt to the desired viewing angle.
2.
Hand tighten the Knob under the Projector Platform and
3.
slowly release the Projector Platform.
Note: Ensure the Projector Platform is stable before
releasing.

Cable Management

Route the Cables from the Projector and Laptop down
1.
through either of the two openings in the Projector
Platform and along the Support Pole.
Clip the open end of the Cable Clip over the Cables and
2.
onto the Support Pole.
Repeat step 2 for the second Cable Clip.
3.
14