Table of Contents
Advertisement
3
Device overview
Membrane vent covering the pushbutton
(tightening torque: 0.6 - 0.8 Nm)
2 threaded holes
M6 x 9 mm
for clamping block
36 mm
Type plate with
product name
and serial number
OTMC 100 does not provide an ON/OFF switch. The device automatically powers up after supply
voltage is provided via Ethernet (PoE).
The LED indicates the device status:
LED continuously off
LED lights red
LED flashes red
LED lights orange
LED flashes green
LED lights green
The pushbutton can be accessed after unscrewing the water-tight membrane vent.
OMICRON
Threaded hole
1/4" BSW x 6.5 mm
for temporary mounting
on a stand
106.2 mm
LED
Waterproof RJ45 connector
acc. to IEC 61076-3-106,
variant 4
OTMC 100 is not supplied with power via the RJ45 Ethernet
connector.
Boot process during power-up or device reboot is in progress.
Software update is in progress.
ATTENTION: Do not disconnect OTMC 100 from its PoE source
(Ethernet network) during a software update!
Intermediate state when initiating a factory reset (see also
procedures performed directly on the device
OTMC 100 is in the recovery mode, waiting for new software. In the
recovery mode, the device provides only a rudimentary web interface
just allowing for the upload of a software image.
OTMC 100 is ready for operation.
The green LED does not provide information about the
number of satellites received or the actual time accuracy
provided by OTMC 100. Such information are displayed in
the Status pages (see page 37) of the web interface.
Device overview
Weight: < 500 g
Degree of protection:
IP67 (for outdoor use) if the waterproof
RJ45 connector is inserted properly
Protective cap
14.5 mm
Ø 115.5 mm
Operating
on page 31).
Base plate
13
Advertisement
Table of Contents
