Table of Contents
Advertisement
OTMC 100 Series User Manual
7.3.5 Log & Notification page
Select the corresponding pane to specify your settings for the logging of system messages and the
event notification. Click the Save button to save and apply your log & notification settings specified in
the individual tabs to OTMC 100.
7.3.5.1
Log pane
Level
Target
Remote host &
Remote port
Remote transport
Enabled sources
72
Use this list box to select the level as of which you want to have system
messages logged to the selected target. Lower levels include the messages
of higher levels.
The following levels are available (starting from the lowest level): Debug,
Info, Warning, Error, Critical.
Use this list box to select the target where you want to have the system
messages logged to:
Local logfile only: Logging is performed to the internal log file that can be
viewed using the
Log Viewer page
Local log and IPv4 syslog server and Local log and IPv6 syslog server:
Logging is performed to the internal log file and to the specified syslog
server for IPv4 or IPv6 installed in the network.
Use this field to specify the hostname and port number of the syslog server
in the network used as log target for the system messages.
Only active if the Target list box is set to Local log and IPv4/IPv6 syslog
server.
Use this field to specify the network transport protocol of the IPv4 or IPv6
syslog server, if selected in the Target field.
Select UDP (User Datagram Protocol) or TCP (Transmission Control
Protocol).
Select the corresponding check box to enable logging for a particular
message type (for example, GPS messages, PTP messages etc.).
(see page 53) in the Status section.
OMICRON
Advertisement
Table of Contents
