Omicron Lab OTMC 100 Series User Manual page 18

OTMC 100 Series User Manual
Insert the connecting pipe (4) to the clamping blocks
on OTMC 100 and the mast clamp as shown in the
figure.
Align the OTMC 100 device in an upright position as
shown in the figure and tighten both clamping screws
(5) of the clamping blocks evenly with a tightening
torque of 5 Nm.
Assemble the delivered waterproof RJ45 connector
to the Ethernet cable according to the accompanying
assembly instructions and insert it to the RJ45
connector on the base plate of OTMC 100. Use
suitable cable ties to fasten the Ethernet network
cable to the connecting pipe and the mast.
Always use the waterproof RJ45 Ethernet
connector supplied with OTMC 100 in order
to maintain the watertightness of the
device. Do not use OTMC 100 outdoors
without a waterproof connector inserted.
The clamping blocks provide holes for
horizontal and vertical mounting of the
connecting pipe. Therefore, it is also
possible to mount OTMC 100 on the top of
a vertically mounted connecting pipe, as
shown in the figure on the right.
18
4
5
OMICRON