Table of Contents
Advertisement
OTMC 100 Series User Manual
Preface & general safety instructions
This user manual provides information about the OTMC 100 series grandmaster clocks, their possible
fields of application and how to install and operate them. It furthermore provides information about
how to access and configure the devices using a computer.
Following the instructions given in this user manual will help you avoid danger, repair costs and down
time, and help maintain the reliability and life of OTMC 100.
In addition to the user manual, the applicable safety and lightning protection regulations in the country
and at the site of operation as well as the usual technical procedures for safe and competent work
should be observed.
Safety symbols used
In this documentation, the following symbols indicate safety instructions for avoiding hazards.
WARNING
Death or severe injury can occur if the appropriate safety instructions are not observed.
CAUTION
Minor or moderate injury may occur if the appropriate safety instructions are not
observed.
NOTICE
Equipment damage or loss of data possible.
General safety instructions
Before operating OTMC 100, carefully read the following general safety instructions:
•
OTMC 100 may only be used in a safe technical condition taking into account its defined purpose,
safety requirements and possible risks as well as the operating instructions given in this user
manual.
•
OTMC 100 is exclusively intended for the application areas specified in chapter
Designated Use
on page 8. The manufacturer or the distributors are not liable for damage
resulting from unintended usage. The user alone assumes all responsibility and risks.
•
Do not open OTMC 100. Opening the device invalidates all warranty claims.
•
OTMC 100 is an SELV device (Safety Extra Low Voltage) which is supplied with power by Power
over Ethernet (PoE according to IEEE 802.3af). It may only be connected to Ethernet network
ports or Power over Ethernet power supplies.
•
Always use the waterproof RJ45 Ethernet connector supplied with OTMC 100 in order to maintain
the watertightness of the device. Do not use OTMC 100 outdoors without a waterproof connector
inserted.
6
Introduction and
OMICRON
Advertisement
Table of Contents
