Elitegroup Computer Systems P6IWM Manual page 50

Boot Up Floppy Seek (Enabled)
If this item is enabled, it checks the size of the floppy disk
drives at start-up time. You don't need to enable this item un-
less you have a legacy diskette drive with 360K capacity.
Boot Up NumLock Status (On)
This item defines if the keyboard Num Lock key is active when
your system is started.
Gate A20 Option (Fast)
This item defines how the system handles legacy software
that was written for an earlier generation of processors. Leave
this item at the default value.
ATA 66/100 IDE Cable Msg. (Enabled)
Enables or disables the ATA 66/100 IDE cable message. This
message appears during boot when you are using a 40-pin
cable on your ATA 66/100 hard disk.
Typematic Rate Setting (Disabled)
If this item is enabled, you can use the following two items to
set the typematic rate and the typematic delay settings for
your keyboard.
•
Typematic Rate (Chars/Sec): Use this item to define
how many characters per second are generated by a
held-down key.
•
Typematic Delay (Msec): Use this item to define how
many milliseconds must elapse before a held-down
key begins generating repeat characters.
Security Option (Setup)
If you have installed password protection, this item defines if
the password is required at system start up, or if it is only re-
quired when a user tries to enter the Setup Utility.
OS Select For DRAM > 64 MB (Non-OS2)
This item is only required if you have installed more than 64
MB of memory and you are running the OS/2 operating sys-
tem. Otherwise, leave this item at the default.
44