Getting Started; Contents Of The Package - Unify OpenScape DECT Phone R6 User Manual

Getting started

Contents of the package

•
One handset
•
One battery cover (rear cover for the handset)
•
One battery
•
One belt clip
•
One rubber cover for the headset socket
•
One rubber cover for the USB connection
•
One user guide
The charging cradle is designed for use in closed, dry rooms within a temperature
range of +5°C to +45°C.
Never expose the telephone to heat sources, direct sunlight or other electrical
devices.
Protect your telephone from moisture, dust, corrosive liquids and vapours.
The device's feet do not usually leave any marks on surfaces. However, due to the
multitude of different varnishes and polishes used on furniture, contact marks on the
surfaces cannot be completely ruled out.
This device is only suitable for a maximum installation height of 2 m.
Connecting the charging cradle
¤
Connect the flat plug of the power adapter
¤
Plug the power adapter into the power socket
To remove the plug from the charging cradle again:
¤
Disconnect the power adapter from the mains
power supply.
¤
Press the release button
3
¤
Pull out the plug .
4
Setting up the handset for use
The display is protected by a plastic film.
Inserting the batteries
Only use rechargeable batteries, as this could otherwise result in significant health
risks and personal injury. For example, the outer casing of the batteries could be
destroyed or the batteries could explode. The device could also malfunction or be
damaged as a result of using batteries that are not of the recommended type.
¤
Insert the batteries (for
correct +/- direction, see
diagram).
Getting started
.
1
.
2
.
Please remove the protective film!
¤
Line up the battery cover at
the recesses with the inside
of the casing .
3
¤
Press the cover until it
clicks into place.
2
1
3
To re-open the battery cover:
¤
Remove the belt clip
(if attached).
¤
Use your fingernail to reach
into the recess and pull the
battery cover up 1 .
9
4