Advertisement
IN ILLUSTRATOR:
Choose F ILE > P RINT . Click on P REFERENCES .
Click on P ROPERTIES . These are GENERIC properties for this laser cutter,
regardless of software.
Note: PIECE SIZE is 609 mm x 457 mm, and usually you want to start the cut from
TOP LEFT (click on little icon).
Note: sometimes you need to go into the SETUP twice for the piece size to register.
Colour mapping to set different cut speeds depending on the colour of the layer:
Advertisement
Need help?
Do you have a question about the HELIX and is the answer not in the manual?
Questions and answers