Timer Alarm (Nap Function) - Silvercrest SRWK 800 A1 Operating Instructions Manual

Pausing the alarm (SNOOZE function)
♦ Press the SNOOZE/DIMMER button
(alarm signal or radio) for about 9 minutes . You can repeat this
up to six times . Then the alarm switches off . While the alarm is
paused, the display flashes
♦ If you press the
the SNOOZE function is active, the function is switched off and
the alarm is no longer active .
Switching off the alarm
♦ When the alarm sounds at the set time, press the
the │‒ button
for Alarm 2 . The alarm stops and remains off for 24 hours .
NOTE
► If the alarm is not stopped manually, the device will automatical­
ly turn off the alarm after 60 minutes .
Switching the alarm on/off
♦ In standby mode, press the
button to switch Alarm 1 or Alarm 2 on or off:
and/or
–
The alarm is switched on .
and/or
–
The alarm is switched off .

Timer alarm (NAP function)

Using the NAP function, you can set a timer alarm that will wake you
up with an alarm signal after 1–120 minutes .
♦ Press the SLEEP/NAP │ 12 / 24 button
NAP and 01 appear on the display
♦ Press the SLEEP/NAP │12 / 24 button
alarm time between 01 and 120 minutes . After approx . 3 sec­
onds, the normal display appears again and the NAP function is
started automatically . NAP appears on the top of the display
SRWK 800 A1
│‒ or the
5
for Alarm 1 or the
5
│‒
and the alarm time are displayed:
and the alarm time are not displayed:
to pause the alarm
6
or and SNOOZE .
│+/MEM
│+/MEM button
or the
5
for about 2 seconds .
8
.
1
repeatedly to set the
8
GB │ MT
button while
7
/AMS or
4
7
│+/MEM
7
1
│ 89
.
■