Safety Regulations; Description Of Hazard Symbols; Dangers In Case Ofnon-Observance Of Safetyregulations; Safe Use - Berner System 60/20 Manual

Safety regulations

Description of Hazard Symbols

General danger symbol
Failure to comply with safety regulations
means danger ( injuries )
(Figurine 5140 of IEC 60417-1)
Danger symbols directly attached to the device must be followed and readability
must be ensured at all times.

Dangers in case ofnon-observance of safetyregulations

Failure to comply with the safety regulations can lead to danger to persons, the environment
and to the inductionsystemitself. In the event of non-compliance with the safety regulations,
there is no right to claim any damages.
In detail, failure to observe the following risks may result in the following risks
( Examples):
Danger to persons due to electrical causes
-
Danger to people from overheated pans
-
Danger to persons due to overheated storage area (ceramic field)
-

Safe use

The safety provisions of this manual, the existing national rules on electricity to prevent
accidents and any internal working, application andsafetyregulations must be followed.
Attention! Cookware may only be placed on the stove with a full extent. Do not place hot
-
pots or pans on the control panel, displays or hobs. Ignoring this notice will damage the pots
and equipment. Effect in ignoring: Pots are welded together, burning the joint material by
heat of the pots and thus destroying the seal, leading to penetration of moisture and grease
and can thus lead to the defect of the device. Defect of the displays or control panels.
If the ceramic glass is torn or broken, the inductiongerät mustbe switched off and
-
disconnected from the electrical supply. Do not touch any parts inside the induction.
The ceramic field is warmed by the heat of the pan. To avoid injuries (burns), do not touch
-
the ceramic field.
Please be wareify against hot food and liquids.
-
PLEASE NOTE: Warning of possibly slippery ground in the vicinity of the device. This can
-
lead to injuries.
Ver. 3.6
This symbol warns of dangerous tension.
(Figurine 5036 of IEC 60417-1)
This symbol warns against non-ionizing electromagnetic radiation.
Attention
In case of improper use
may cause minor injuries or
damage to property!
Attention
The user manual must be read before using or
maintaining the device.
Page 4 Of 44
© Bernese cooking systems 2018
17.07.2014