Pyro-Sensor Itc; Warming Function With Potentiometer; Warming Function With Pyro-Sensor Itc And Electronic Potentiometer - Berner System 60/20 Manual

Display Example
Setpoint
Actual
Residual
heat

Pyro-Sensor ITC

The Pyro-Sensor (ITC) has a center lighting, which lights through the ceramic glass:
Display Importance
Pot detection
Residual heat indicator

Warming function with potentiometer

Instead of power levels 1 to 3, the warming temperature can be set from 70-110°C. This is
followed by the performance settings from level 4 to 9.
Elements Description
Rotary switch
0 position
Rotary switch
Range α40-120°
Rotary switch
Range α120-320°

Warming function with pyro-sensor ITC and electronic potentiometer

When the warming function is switched on, the start-turning direction can be used to
be elected. After at min. 1 second off state, the direction of rotation is detected.
Thus, in operation, the rotary switch can also be rotated via the 0-position, without
change the operating mode.
Elements Description
Rotary switch
0 position
Ver. 3.6
Importance Declaration
Setpoint 90°C
Temperature too
low
Setpoint is represented by point.
Setpoint 90°C
Point on the right indicates heating
Temperature +/-
status
4°C
Setpoint 90°C
Temperature too
high
Actual value
125°C
Temperature too
low
Actual value appears every 10 sec for 2
sec.
Actual value
105°C
Temperature too
low
Warning "Hot"
Induction switched off and actual value
Residual heat
> 45°C, every 10 sec for 2 sec.
indicator
Declaration
Flashes when induction is turned on and no
pot is present
Lights up when induction is switched off
and actual value > 45°C
Function
From
Temperature control 70-110°C (level 1-3)
Power control level 4-9
Function
From
Page 17 Of 44
© Bernese cooking systems 2018
17.07.2014