Potentiometer Error Handling; Troubleshooting - Berner System 60/20 Manual

The inductiongcan only be opened by approved and trained service personnel. Stop any work,
the Heating zone ( ceranglass ) can be torn or broken. The inductiongerät must be switched off
immediately and From Network Separated Be. Do not touch any parts inside the device.
Attention
when opening the induction device!
Dangerous tension!

Potentiometer Error Handling

If the potentiometer fails during operation or if no potentiometer is detected (and no touch
control), the error message "P" appears. This is reset as soon as a potentiometer is detected. If
a second potentiometer is connected after starting the device, this is not detected.
In the event of a failure of a potentiometer in the dual-potentiometer control system, it is still
possible to continue working with the functional potentiometer. In this case, the error message
"P" appears in the switched off state.
In the event of failure of the master potentiometer, further work can be carried out if a slave
potentiometer is present. If a slave potentiometer fails, the channel can still be operated with
the master potentiometer. The error message "P" appears in these cases when the state is
switched off.

Troubleshooting

Error
No heating up
Power indicator lamp is OFF
Insufficient heating capacity
Power indicator lamp is
Ver. 3.6
Possible cause
No power supply
Power knob in OFF position
Main switch is OFF
Pan too small
( bottom of the pan under
12cm)
Pan is not placed in the middle of
the heating zone (pan cannot be
recognized)
Unsuitable pan
Inductiongerät defective
Used pan is not ideal
Page 27 Of 44
Measures taken by operators or
service personnel
Check that the device is connected to the power
supply (power cable plugged in) or that the main
switch is turned on.
Turn the power knob into one position
Turn the main switch into one position
Use the appropriate pan.
Slide the pan into the center of the heating zone
Choose a pan suitable for induction *1
Contact your repair service supplier. Unplug the
device from the mains.
Choose a pan suitable for induction. Compare the
results with'your' pan.
© Bernese cooking systems 2018
17.07.2014