Powerstar Function ( Bi2Ktt3.5 ); Functional - Berner System 60/20 Manual

Powerstar Function ( BI2KTT3.5 )

The 230V double generator automatically optimizes the maximum power of 3.5kW. There can be
optionally 2 cooking points with a maximum output of 1.8 kW each or only the front cooking
unit with 3.5 kW or the rear cooking unit with 3.0 kW. The other cooker must be switched off.
When both cookers are operated, the digital display displays level 7 at full power on both
cookers. As soon as only one cookroom is occupied again, the display displays level 9 at full
power.
The Power Star QUnktIon Wird WIe Qolgt
AktIvieRt:
Vordere KocHstelle Belegt, hintHee AusgeschaAccordingen=
3.5 kW

Functional

Attention
The hot pan heats up
transferred to the heating zone.
To avoid injury, do not touch the heating
Use a pan suitable for induction with a minimum floor diameter of 12 cm.
For the functional test of devices with main switches, they must first be switched on,
then proceed as described.
Place the pan in the middle of the heating zone and pour some water into it.
With LED: Turn the power knob to ON (a position between Min and Max). The power
-
indicator lamp LED green flashes (cooking level 10%-30%) or lights (cooking level 30%-
100%), the water is heated.
With digitaldisplay : (1-9) Turn the power knob to ON (a position between Min and Max).
-
Display shows the selected power between (1-9).
With LED: Remove the pan from the heating zone, so the power indicator lamp must flash
-
(pan search).
Put the pan back on the heating zone; the power indicator lamp lights up again and the
-
heating process starts anew.
Rotate the power knob to the 0 position. The heating process is stopped and the power
-
indicator lamp switches off.
The luminous power indicator lamp indicates that energy is transferred to the pan.
-
With digitalhe display: (1-9) Remove the pan from the heating zone, so the display (pan
-
search) must display this icon see error messages.
Put the pan back on the heating zone; the digital display again shows the selected power
-
and the heating process starts anew.
Rotate the power knob to the 0 position. The heating process is stopped and the display is
-
switched off.
The number in the display indicates that energy is transferred to the pan.
-
If the power indicator and or LED or digitale indicator remains switched off or flashes only
very briefly, check the following:
Is the inductiongerät connected to the power grid or main switch in?
-
Ver. 3.6
zone.
Page 21 Of 44
© Bernese cooking systems 2018
17.07.2014