Berner System 60/20 Manual page 29

ON (lights)
No reaction to turning the power
knob
Heating capacity stops and off
within minutes.
Fan works
Heating capacity stops and off
within minutes. Fan is not
working.
Heating capacity stops and
downs within minutes
(after longer, continuous
operating time)
Small metallic objects
( e.B. spoon, knife ) are
heated on the heating zone
*1)To check whether the pan is suitable, use a permanent magnet, which must remain slightly
attached to the bottom of the pan. If not, your pan is unsuitablefor induction. Choose a pan
material suitable for induction.
*2)The ventilation begins to work when the temperature of the cooling plate exceeds 45°C. At
cooling plate temperatures above 70°C, monitoring automatically reduces performance to keep
the power part under normal operating conditions. The inductiongerät continues normally with
reduced maximum power.
If the mains connection line of this device is damaged, it must be replaced by the
manufacturer or its customer service or a similarly qualified person to avoid hazards.
Ver. 3.6
Air cooling system is
disabled/blocked
Air filter is dirty.
Ambient temperature is too high
(the cooling system cannot keep
the cooker in normal operating
temperatures *2
A phase is missing
Inductiongerät defective
Power controller defective
Air cooling system is
Blocked/disturbed
Fan dirty
Fan or fan monitoring defective
Coil overheated,
Heating zone too hot.
Empty pan
Overheated oil in the pan
Pan detection incorrect
Set
Page 28 Of 44
Make sure that the air supply and export are not
obstructed/blocked.
Clean or replace filters.
Make sure that no hot air is sucked in. Reduce the
ambient temperature. The temperature must not
exceed 40°C / 110 °F.
Check the backups.
Contact your repair service supplier. Disconnect the
device from the mains.
Make sure that the air supply and export are not
blocked.
Cleaning fans
Contact your repair service supplier. Disconnect the
device from the mains.
Turn off the device, remove the pan and wait for the
heating zone to cool down.
Check the control print
(only service personnel of supplier!)
© Bernese cooking systems 2018
17.07.2014