Operation; Cooking Process; Comfort; Pot Detection - Berner System 60/20 Manual

Is the power knob on position ON?
-
Do you use an induction-ready pan (test with permanent magnets) with a floor diameter of at
-
least 12 cm?
Is the pan in the middle of the heating zone (except appliances with suction coils with 5-
-
sensor technology or surface coil)?
To check whether the pan material is suitable, use a permanent magnet, which must
remain slightly attached to the bottom of the pan. If not, your pan is unsuitablefor
induction.
Choose a pan recommendedfor induction.
If the inductiongerät does not work despite the test, you can see under the item Error
detection/Troubleshooting.

Operation

Cooking process

The device is immediately ready for operation. The luminous or flashing power indicator light or
digital indicator indicates (1-9) that energy is directed to the pan. The power level is selected by
rotating the power knob. The inductive power transmission depends on the position of the
potentiometer.
Position MIN >minimum power
Position MAX>maximum power
Due to the following circumstances, the cook must be more attentive than when cooking with
conventional cooking systems. If the cooking stage is changed by means of a power knob, the
cooking material reacts immediately. Empty pans or pots heat very quickly. Never place pans on
the ceramic hob without any contents, first add the fat or liquid to the pan and then start
cooking. Adjust the heating power by means of a rotary knob exactly according to the desired
cooking method. The pan should always be placed in the middle of the heating zone (except
appliances with surface coil or suction coil with 5-sensor technique),otherwise the bottom of
the pan is heatedunevenly. When heating oil or grease, continuously check the pan to prevent
overheating or burning of the oil or grease.
Attention! Cookware may only be placed on the stove with a full extent. Do not place hot
pots or pans on the control panel, displays or hobs. Ignoring this notice will damage the
pots and equipment. Effect in ignoring:
material by heat of the pots and thus destroying the seal, leading to penetration of
moisture and grease and can thus lead to the defect of the device. Defect of the displays
or control panels.

Comfort

The inductiongerät transmits energy only when a pan is on the heating zone. The position of the
power knob has no influence on this. When you remove the pan from the heating zone, the
transfer of energy to the pan is stopped immediately. When the pan is returned to the heating
zone, the preselected power is transferred back to the pan. Switching off with the rotary knob
stops the cooking process. However, the device remains ready for operation (standby), only
disconnecting from the main surge (or switching off the main switch if available) makes the
device powerless.

Pot detection

The pot detection has the task of switching on the inductive heating when a suitable cookware is
installed on the ceramic field, or switched off again if
this is removed.
The pot detection is carried out inductively with test pulses every second, after 1 minutes the clock
rate is reduced to a 5 seconds.
Ver. 3.6
Pots are welded together, burning the joint
Page 22 Of 44
© Bernese cooking systems 2018
17.07.2014