Decommissioning; Error Detection - Berner System 60/20 Manual

Master-Potentiometer function for both channels on. If still
additional potentiometers are connected to the device, they will only work if the
Master-Potentiometer is set to zero position.
Energy
The power limits are set individually for single operation and dual operation per application.
Thus, after application, one is reduced the performance in dual operation in order not to exceed
the maximum total power. (mostly affects 1x230V inductions)
If energy management is discontinued, the power limits are
1st level (this function is only effective at power level 2)
This also allows for the total load for applications (preferably 3x400V inductions)
reduce in dual operation
With the 1x230V induction, the maximum power level in the display is limited to level 7.
Behaviour in dual operation
Potentiometer 1
From
A
A
From
Energy management with Spin Control
If the energy reduction is active, the energy symbol lights up at the lower right of Spin Control.

Decommissioning

If the inductiongerät is not in use, make sure that the main switch or power rotary knob is not
turned on unattended. If you do not use the device for a long time (several days), disconnect
the device from the main network or turn off the main switch. Make sure that no liquid can get
into the grigand do not clean the device with liquid.

Error detection

Warning: During cleaning or maintenance and when parts replace, the equipment must
be disconnected from the power supply.
Ver. 3.6
Potentiometer 2
From
From
A
A
Page 26 Of 44
Reaction
Both channels are made of
Only channel 1 in operation
No energy reduction
Both channels in operation
Energy reduction active
Channel 1 & 2 have reduced
maximum power
Only channel 2 in operation
No energy reduction
© Bernese cooking systems 2018
17.07.2014