Table of Contents
Advertisement
During operation, the pot detection is carried out by the recorded power.
The sensitivity can be adjusted by means of a DIP switch, so that even small cookware is detected.
If an unsuitable cookware (e.B. aluminum pot) is placed, the error message "F" appears.
External display
Startup
Display Time
1st second
2nd second
3rd second
4th second
5th second
Normal operation
Display Importance
Residual heat
indicator
Pot detection
Operation
Reduction 1
Reduction 2
Reduction 3
Reduction 4
Pot rating
The pot evaluation determines how well a cookware is suitable for the
induction system.
Poor cookware, leads to excessive heating of the electronics and to performance limitation. Poor
efficiency and limited power control
are further significant disadvantages.
To display the pot rating, the induction must be set to maximum performance.
The evaluation varies depending on the connected peripheral.
Pot rating does not work Smart Power Dual operation.
Pot rating light with 1 display
Set to full power and observe flashing point at the 7-segment display at the bottom right.
reduce power until the point is permanently lit.
The performance level, which is then displayed, corresponds to the pot rating
The larger the number, the better the cookware (values of 1-9).
Ver. 3.6
Declaration
Testing the segments
Operating mode Pulse
Software version 1st digit
Software version 2nd digit
Software version 3rd digit
Declaration
PT1000 Hob Temperature > 45°C
induction switched on but no pot is put on.
Decimal point lights up with pot detection every second
after 1 min every 5 seconds
Power display 1-9 and decimal point continuous lights:
Performance is surrendered
Decimal point flash1s: KK temperature limit
Decimal point flash500ms: coil temperature limit
Decimal point flashing 200ms: Power limit
Decimal point flash100ms: HF peak limit (not optimal
pan material)
Page 23 Of 44
© Bernese cooking systems 2018
17.07.2014
Hide quick links:
Advertisement
Table of Contents
