Yamaha XF375 Owner's Manual page 30

Components
UP
1
DN
1
1. Power trim and tilt switch
UP
1
DN
1. Power trim and tilt switch
The switch on the control grip controls all outboard motors
at the same time.
For instructions on using the power trim and tilt switches,
see pages 45 and 46.
EMU35041
Tilt limiter
This outboard motor is equipped with a tilt limiter that con-
trols the tilt range.
TIP:
Consult your Yamaha dealer about changing the setting.
EMU47780
Tilt support lever for power trim and tilt model
To keep the outboard motor in the tilted up position, lock the
tilt support lever to the clamp bracket. Make sure that the le-
ver is securely held in place by the bolts.
1
1. Tilt support lever
25
UP
1
DN
ZMU07997
UP
1
DN
1
TIP:
To use the lower tilted up position, remove the upper bolts.
ECM00661
NOTICE
Do not use the tilt support lever or knob when trailering
the boat. The outboard motor could shake loose from
the tilt support and fall. If the motor cannot be trailered
in the normal running position, use an additional support
device to secure it in the tilt position.
EMU40762
Cowling lock lever
The cowling lock levers are used to secure the top cowling.
1
1. Cowling lock lever
1
1. Cowling lock lever
EMU40803
Flushing device
The flushing device is used to clean the cooling water pas-
sages of the outboard motor using a garden hose and tap
water. For instructions on using the flushing device, see
page 50.
1
1. Flushing device
1