Power Trim And Tilt Unit Will Not Operate; Steer-By-Wire System Will Not Operate - Yamaha XF375 Owner's Manual

Trouble Recovery
1
3
2
2
2
2
1. Fuse box cover
2. Spare fuse (10 A, 15 A, 20 A, 30 A, 70 A, 100
A)
3. Fuse puller
TIP:
 RC: Remote control
 ETV: Electric throttle valve
 DI: Direct injection
 ECU: Engine control unit
 STRG: Steering
 PTT: Power trim and tilt
If a fuse has blown, replace the fuse according to the follow-
ing procedure.
1. Turn the main switch to the "
2. Remove the fuse box cover.
3. If the fuse is secured using screws, remove the screws,
and then remove the fuse. Install a spare fuse of the
proper amperage, and then tighten the screws.
1. Screw
2. Fuse
4. If the fuse is not secured using screws, remove the fuse
using the fuse puller. Install a spare fuse of the proper
amperage.
1
1. Fuse puller
Consult your Yamaha dealer if the new fuse immediately
blows again.
65
2
2
2
" (off) position.
1
2
EMU40984

Power trim and tilt unit will not operate

EWM02331
WARNING
Never get under the engine while it is tilted. Severe injury
could occur if the outboard motor accidentally falls.
If the outboard motor cannot be tilted up or down using the
power trim and tilt unit because of a discharged battery or a
failure with the power trim and tilt unit, the outboard motor
can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turning it counter-
clockwise until it stops.
1
1. Manual valve screw
3. Tilt the outboard motor up manually to the desired posi-
tion, and then tighten the manual valve screw by turning
it clockwise.
EMU47560

Steer-by-wire system will not operate

If the steer-by-wire system does not operate, the outboard
motor can be steered manually.
To steer the outboard motor manually
1. Remove the clamp bracket cover by removing the bolts.
1
1. Bolt
2. Clamp bracket cover
2. Loosen the nut until it stops.
2 2