Driving The Tractor And Mower - Schulte FX-209 Operator's Manual

Using the tractor 3-point hitch control lever-lift type
or hydraulic remote lever-pull type, raise the mower
off the ground about 6", or just high enough to clear
any ground obstacles. When raising the mower,
make sure all connection points are securely
attached and at least 1" clearance is maintained
between the driveline and the deck. If necessary,
place an upper lift stop on the 3-point hitch control
lever to limit the height the mower can be raised to
avoid driveline damage.

9.7 Driving the Tractor and Mower

Start off driving at a slow speed and gradually increase your speed while maintaining complete control of the
tractor and mower. Moving slowly at first will also prevent the tractor from rearing up and loss of steering
control. The tractor should never be operated at speeds that cannot be safely handled or which will prevent the
operator from stopping quickly during an emergency. If the power steering or engine ceases operating, stop
the tractor immediately as the tractor will be difficult to control. If the tractor becomes stuck or the tires are
frozen to the ground, reverse the tractor out to prevent overturning.
Perform turns with the tractor and mower at slow
speeds to determine how the tractor with the mower
handles a turn. Determine the safe operating speed
to maintain proper control of the tractor when
making turns. When turning with an attached rear
implement, the overall length of the working unit is
greatly increased. Allow additional clearance for the
mower to swing when turning.
Be particularly careful when transporting the Implement with the Tractor. Turn curves or go
up hills only at a low speed and using a gradual steering angle. Rear mounted implements
move the center of gravity to the rear and remove weight from the front wheels.
certain, by adding front ballast, that at least 20% of the tractor's weight is on the front wheels
to prevent rearing up, loss of steering control or Tractor tip-over. Slow down on rough or
uneven surfaces to prevent loss of steering control which could result in property damage
or possible injury. Do not transport unless 3-Point lift lever is fully raised and in the latched
transport position. Dropping implement in transport can cause serious damage to the
tractor and/or Implement and possibly cause the operator or others to be injured or killed.
(S3PT-02)
FX-209 07/19
© 2019 Alamo Group Inc.
OPERATION
Operation Section 4-29
Make