Installation - ADJ FOCUS WASH 400 User Manual

IP RATING
This device is IP30 rated. It is protected against instrusion of solids larger than 2.5mm in size, such
as tools and thick-gauge wires. The device is NOT protected against liquid instrusion of any
kind.
FLAMMABLE MATERIAL WARNING!
Keep device a minimum of 5.0 feet (1.5m) away from flammable material and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
MULTI-DEVICE DAISY CHAINING
• When connected to 240V power, up to 3 devices may be daisy chained together.
• When connected to 110V power, daisy chaining is NOT permitted. In this situation, only
operate the fixture as a single standalone device!
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
The unit MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
Before installing or mounting any device, a professional equipment installer MUST be consulted to
determine whether the mounting structure or surface is properly certified to safely support the com-
bined weight of the fixture, clamps, cables, and accessories.
Overhead fixture installations must always be secured with a secondary safety attachment, such as
an appropriately rated safety cable that meets all local, national, and country codes and regulations.
Maximum ambient operating temperature is 113°F (45°C). Do not operate this device when ambient
temperature exceeds this value.
This fixture should be installed in areas outside walking paths, seating areas, and areas where unau-
thorized personnel might be able to reach the device by hand.
NEVER stand directly below the fixture when rigging, removing, or servicing.
Allow approximately 15 minutes for the fixture to cool down before servicing.
ADJ Products, LLC - www.adj.com - Focus Wash 400 User Manual Page 11

INSTALLATION