Nexcom NEX 614 User Manual page 54

Chapter 3: BIOS Setup
Secure Erase
This section is used to configure the secure erase settings.
Aptio Setup Utility - Copyright (C) 2016 American Megatrends, Inc.
Advanced
Secure Erase
Secure Erase mode [Simulated]
Force Secure Erase [Disable]
Version 2.17.1255. Copyright (C) 2016 American Megatrends, Inc.
Secure Erase Mode
Configures the behavior of the secure erase function.
Force Secure Erase
Enables or disables force secure erase function.
Copyright © 2016 NEXCOM International Co., Ltd. All Rights Reserved.
SATA Configuration
This section is used to configure the SATA drives.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
SATA Controller(s)
Enables or disables the SATA controller.
SATA Mode Selection
Configures the SATA mode.
AHCI
40
Aptio Setup Utility - Copyright (C) 2016 American Megatrends, Inc.
Advanced
[Enabled]
SATA Controller(s)
SATA Mode Selection [AHCI]
SATA Test Mode [Disabled]
Serial ATA Port 0 32GB SATA Flas (32.2GB)
Software Preserve SUPPORTED
Port 0 [Enabled]
Hot Plug [Disabled]
External SATA [Disabled]
[Disabled]
Spin Up Device
SATA Device Type [Hard Disk Drive]
Topology [Unknown]
Device Sleep [Disabled]
SATA DEVSLEP Idle Timeout Config [Disabled]
Serial ATA Port 1 Empty
Software Preserve Unknown
Port 1 [Enabled]
Hot Plug [Disabled]
[Disabled]
External SATA
Spin Up Device [Disabled]
SATA Device Type [Hard Disk Drive]
Topology [Unknown]
Device Sleep [Disabled]
SATA DEVSLEP Idle Timeout Config [Disabled]
Serial ATA Port 2 Empty
Version 2.17.1255. Copyright (C) 2016 American Megatrends, Inc.
This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
▲
Enable or disable SATA Device.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
▼
NEX 614 User Manual