Protection Functions - Cobra G100 Complete Instructions

6.5 - Deactivating the ultrasonic volumetric sensor.
If you wish to activate the protection system with the windows left open or when a
passenger will be staying inside the passenger compartment, it is possible to deactivate
the volumetric sensor so that it will not generate any alarms.
1) Activate the system by pressing radiocontrol button "A".
2) Press radiocontrol button "A" again within 25 s.
If a hyperfrequency or anti - lifting sensor is installed, it is possible to disable it by
pressing button "A" twice within 25 s. The reception of the signal is confirmed by one
flash of the direction indicators and by an acoustic signal from the buzzer (if enabled).
The sensor has been disabled; all the other protection functions remain active. The
sensors will be automatically reactivated the next time the system is armed.
6.6 - Panic Alarm.
Whenever you press radiocontrol button "A", provided 25 s have elapsed after arming the
system, it will produce an alarm cycle (siren sound and flashing direction lamps). If the
Car Finder function is enabled, press radiocontrol button "A" twice (2 consecutive presses).
To stop the panic alarm, press radiocontrol button "B".

6.7 - Protection functions.

When the system is armed, opening the bonnet / boot / door or attempting to start the
vehicle generates an acoustic and visual alarm cycle that lasts approximately 30 s. In
products that include a volumetric sensor, the alarm will be triggered off by intrusion into
the passenger compartment. At the cycle's end the system stays armed.
6.8 - Alarm record.
If any alarms have occurred during your absence, the direction lamps and buzzer will
emit their signals 5 times instead of once.
COMPLETE INSTRUCTIONS G100
B
A
43