Cobra G100 Complete Instructions page 31

20 - REPLACE OF THE BATTERY OF RADIOCONTROL.
20.1 -
Flat battery in the radiocontrol device.
If when one of the radiocontrol buttons is pressed the LED flashes for a short time or
in an irregular way this means that the battery is low. How to replace the battery.
1. To change the battery, open the radio control shell, being careful to lever it up at
the point the area indicated in the drawing.
2. Remove the battery by extracting it in the manner shown.
3. Wait approximately 10 s.
4. Insert the new battery, taking care to make sure your fingers touch it only on the
sides. Make sure its polarity is correct, as indicated in the diagram.
5. Close the shell and press radiocontrol button "A" checking that the system
responds correctly. Perform the test near the vehicle.
6. Dispose of the empty battery in an appropriate disposal - bin.
7. In the event of loss of both the remote controls an emergency disarming may still
be performed. Reference should be made to the disarming / emergency procedure
(page 60).
62
COMPLETE INSTRUCTIONS G100