Cobra G100 Complete Instructions page 13

6.9 -
Coupling of modules / siren 4310 / satellite alarm ICD31 engine imobiliser
8509 on Cobra Bus line.
On the Cobra Bus line (pin 14) it is possible to connect the following additional modules
(Siren 4310 / anti - lifting module / satellite alarm ICD 31 / Engine lock 8509) by means of
the following programming procedure:
1. Disconnect system.
2. Enter programming mode using the dedicated procedure for the product.
3. Move from page 1 to page 6 by activating and de - activating the panel (+15 ON /
OFF).
4. The storage and completion of programming is signalled by flashing indicator
lights.
Repeat from point 1 if a module of the Cobra Bus line is disconnected.
NOTE: with the alarm disconnected, disconnecting a self learning
module from the Cobra Bus line, when the G100 is armed the indicator
lights will flash 8 times and if the Buzzer is activated it will signal 8
times by the buzzer.
ATTENTION!
If both radiocontrol devices have been lost, proceed as follows:
A. Disarm the system by keying in the Pin Code.
B. Cut off the system's power feed (disconnnect the connector from the central
unit).
C. Open a door and the vehicle's bonnet.
D. Turn on the ignition.
E. Reconnect the power feed.
F. Key in the Pin Code.
G. The LED will confirm with a long flash that the code you have entered is correct.
H. After about 5 s the LED will light up with a steady light and by 5 flashes from the
direction indicators to signal that you have entered the self-learning procedure.
I. Ref. subsection 16 point 7 page 58 of the procedure for adding on new radiocontrol
devices for all the transmitters to be enabled.
NOTE: when a new remote control is coupled, the system automatically
prevents use of the previous ones. They can only be used if they are re -
enabled through the self - learning procedure.The system can memorize up
to a maximum of 4 radiocontrol devices.
44
COMPLETE INSTRUCTIONS G100