Cobra G100 Complete Instructions page 30

19.1 - PERSONALISING THE PIN CODE G100.
Since the Pin Code represents a means of access to the system, it must not be left
unattended inside the vehicle. It could be used to disconnect the system or connect the
remote controls without authorisation. The Pin Code may be easily changed as follows:
1. Disconnect the system.
2. Turn on the ignition key "key ON".
3. Open a door and the bonnet and keep them open during programming.
4. Press button "A" on the remote control until the indicator lights flash once to signal
entry into programming mode.
5. Enter the old Pin Code; the confirmation is made by 5 flashes of the direction indicators.
6. Press the button on the emergency panel a number of times corresponding to the first
digit of the Pin Code to be entered. The LED flashes fast every time the button is
pressed.A longer pause is interpreted by the system as the end of entering the first
digit, which is signalled by a long flash of the LED.
7. Repeat this operation for all the other digits.
8. Set the new Pin Code:
•
After entering the fourth digit switch OFF the panel.
•
Repeat the entry of the new code.
If the system verifies the correspondence between the code entered and the one
programmed, the code is stored; the storage is signalled by a 3 s flashing of the indicator
lights and the LED. Close the door at any time to exit from the procedure; the old Pin Code
will remain stored in the system.
CAUTION!
In the event of theft or loss of the PIN CODE CARD contact your supplier.
COMPLETE INSTRUCTIONS G100
61