Recovering An Interrupted Recording - Lectrosonics DCR822 Instruction Manual

DCR822
Load Group and Save Group:
The tuning groups feature allows groups of frequencies to be created, stored and used to constrain tuning. When a
tuning group is assigned, the frequency control is limited to the frequencies contained in thetuning group. The groups
are created using Lectrosonics DCR822 receiver or via Wireless Designer, then the groups are shared with the via IR
sync or microSDHC Memory Card transmission.
Use UP and DOWN arrows to toggle and MENU/SEL to save group
Save Tuning Group
Use UP and DOWN arrows to toggle and MENU/SEL to save group.

Recovering an Interrupted Recording

Recordings can be reliably recovered even if the microSDHC memory card is accidentally removed or the battery
dies while a recording is in progress. If a recording is interrupted, all of the audio is present on the card and can be
easily recovered by the DCR822. The DCR keeps track of the length of the most recent recording so it can supply a
good suggestion for the length to recover. If the length is ever unknown or the DCR's suggestion seems incorrect, it is
always possible to override the suggested length. If in doubt, specify the maximum length possible, in which case the
entire remainder of the card is recovered. All of the interrupted recording will be present, followed by extra contents
which might be random noise or audio from previously deleted recordings.
NOTE: A good battery or external power supply is required to begin the recovery process. If recovery is attempted with a
weak battery, a message will appear saying that a fresh battery will be required.
Once a fresh battery has been installed, power on the DCR and insert the card with the interrupted recording. The
DCR will detect the interrupted recording and display:
INTERRUPTED
RECORDING
FOUND
And then:
Recover?
for safe use
see manual
No
Yes
If "No" is chosen, nothing is done to the card and the DCR will not use the card. If "Yes" is chosen", a prompt appears
asking for the length of the recording to recover, specified as a number of hours and minutes. The default suggestion
will be the approximate length of the most recent recording. It is always safe to recover a longer recording than was
made. To specify the recovery time, use the MENU/SEL button to navigate and specify the hours and minutes fields.
Length to
recover?
hh mm
08:10
Once set as desired, use MENU/SEL to navigate to the "GO" soft button and press the DOWN arrow button to begin
the recovery process. Recovery is nearly instantaneous. When completed, the display will show:
RECOVERY
SUCCESSFUL
16 LECTROSONICS, INC.