Connecting Power To The Cisco Fm Ponte Kit; Connecting Power Through A Lan Rj45 Port - Cisco FM PONTE-50 Installation And Configuration Manual

Connecting power to the Cisco FM Ponte kit

NOTE
For detailed comparative information on which Fluidmesh
hardware
through IEEE 802.3at or IEEE 802.3af power sources, or
through a DC IN power source, refer to
requirements" (page

Connecting power through a LAN RJ45 port

The Cisco FM Ponte kit radio transceiver unit has two Ethernet ports
(Figure 5 (page
Figure 5. Device connector ports
CAUTION
The unit is designed to take power through 24 Vdc Power-
over-Ethernet only, and does not have a dedicated power port.
A 24 Vdc PoE injector is included with the unit. Do not connect
any 48 Vdc PoE injector, and do not attempt to connect any
other source of electrical power to the unit.
Connect the included 24 Vdc PoE injector to the unit by doing the
following steps:
1. Only use a patch Ethernet cable to connect the PoE injector and
the unit.
© 2021 Cisco and/or its affiliates. All rights reserved.
devices are
115).
24)).
Hardware installation
capable of accepting
"Electrical power
Page 24 of 132
power