Connecting The Cisco Fm Ponte Kit To Networking And Communications Hardware; Terminal Assignments For Power And Data Connectors; Rj45 Ethernet - Cisco FM PONTE-50 Installation And Configuration Manual

5.2. Connecting the Cisco FM Ponte kit to networking and
communications hardware

5.2.1. Terminal assignments for power and data connectors

IMPORTANT
Always use outdoor-rated, RF-shielded Ethernet cables when
connecting the Power and LAN ports of a Fluidmesh hardware
device to external hardware.

RJ45 Ethernet

IMPORTANT
Always use outdoor-rated, RF-shielded Ethernet cables, and
RF-shielded RJ45 male connectors (a typical shielded
connector can be seen in the image below).
The terminal assignments for male RJ45 connectors are as shown in the
image below. With the connector in this orientation, the terminals are
numbered 1, 2, 3, 4, 5, 6, 7 and 8 from right to left.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
Page 27 of 132