Management Settings; View Mode Settings - Cisco FM PONTE-50 Installation And Configuration Manual

4. To enable CANBUS support for the unit, make sure the FM-
CANBUS plug-in is installed, then check the Enable CANBUS:
check-box.
5. Save the miscellaneous settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.

7.7. Management settings

7.7.1. View Mode settings

The View Mode window allows the system administrator to grant and
prohibit access to device configuration settings by category.
IMPORTANT
Changing the default password to a strong password is an
extremely important step in preventing security breaches.
If you have logged into the configurator interface using default
login credentials, you will see a notification banner at the
bottom of the screen
Figure 35. Default credentials notification banner
Click the banner to change the view mode credentials. You will
be taken to the VIEW MODE SETTINGS section.
To gain editing privileges for the View Mode settings window requires the
correct administrator user name and password. To change the
administrator user name and password for the current user, do the
following steps:
1. Click the -view mode settings link under MANAGEMENT
SETTINGS in the left-hand settings menu. VIEW MODE
SETTINGS
• The Viewmode Credentials section will be shown
(Figure 36 (page
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
(Figure 35 (page 82)).
83)).
Page 82 of 132