16. Fully tighten the M6 nut and M8 nuts.
CAUTION
Do not over-tighten the nuts. Doing so could damage the
bracket components.
4.2. Installing the radio using tie-wraps
To install the radio transceiver on a wooden or metal utility pole using the
included tie-wraps, do the following steps:
1.
Decide where on the utility pole the radio must be mounted,
taking access to the radio and line-of-sight into account.
2.
Place the radio against the utility pole at the chosen mounting
point (below).
3.
Route the two tie-wraps through the clamp holes of the radio's
mounting lug (below).
© 2021 Cisco and/or its affiliates. All rights reserved.
Installing the radio
Page 17 of 132