Table of Contents
Advertisement
Figure 29. Multicast dialog
2.
Click the Multicast Forwarding drop-down.
3.
Click the Enabled option to enable multicast traffic forwarding, or
click the Disabled option to disable forwarding
7.6.5. SNMP configuration
The SNMP window can be used to configure an SNMP v2c or SNMP v3
service to run on the Cisco FM Ponte kit.
Walk-throughs (no agent-to-manager notifications) and traps (agent-to-
manager notifications enabled) are both supported. If SNMP traps are
enabled, you can specify the server address to which monitoring
information must be sent.
IMPORTANT
The same SNMP configuration must be set for all Fluidmesh
units in the wireless network.
For
configuration, refer to the Fluidmesh SNMP FM-MIB OID Table
and MIB configuration files. These can be downloaded from
the Fluidmesh Partner Portal (Documentation section > User
Manuals > Advanced Manuals.)
To change the SNMP settings, do the following steps:
•
Click the -snmp mode link under ADVANCED SETTINGS in the
left-hand settings menu.
• The default SNMP dialog will be shown
74)).
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
detailed
information
on
Fluidmesh
unit
SNMP
(Figure 30 (page
Page 73 of 132
- Quick Links:
- Unit Configuration
Hide quick links:
Advertisement
Table of Contents
