Table of Contents
Advertisement
3.3. Fluidmesh network addressing
3.3.1. Bridge IP addressing
The Cisco FM Ponte kit can only be operated in Bridge mode, creating a
single point-to-point connection between two wireless network segments.
A simplified example of a Bridge mode connection is shown in
(page
13).
As shipped from the factory, the wired ethernet ports of all Fluidmesh
hardware components are assigned the same default IP address of
192.168.0.10/24.
No default IP address is associated with the wireless interface.
Figure 2. Wireless network architecture (bridge configuration)
3.3.2. Unit identification and addressing
Bridge-capable radio transceiver identification
Regardless of its configuration and operating mode, every Fluidmesh
radio transceiver is shipped from the factory with a unique unit
identification (ID) number. This number always takes the following form:
5.a.b.c
The triplet a.b.c uniquely identifies the individual physical hardware unit,
and cannot be changed.
The unit ID number is used to identify the physical hardware units within
the configurator interface that is used for configuration of the unit.
Network addressing
Fluidmesh radio transceivers
Each Fluidmesh radio transceiver unit has a factory-set IP address of
192.168.0.10, and a Netmask of 255.255.255.0.
© 2021 Cisco and/or its affiliates. All rights reserved.
Getting Started
Figure 2
Page 13 of 132
- Quick Links:
- Unit Configuration
Hide quick links:
Advertisement
Table of Contents
