Rules For Packet Management - Cisco FM PONTE-50 Installation And Configuration Manual

Rules for packet management

Parameter
Default VLAN configuration
The factory-set VLAN parameters for the unit are as follows:
Management VLAN ID (MVID)
Native VLAN ID (NVID)
Native VLAN processing
Port mode (all Ethernet ports)
Traffic classes
The system classifies incoming data packets according to the following definitions:
Signaling
User
Packet tagged with MVID
Access port rules for incoming packets (Case and Action)
Untagged packet from Fluidmesh device
Untagged packet, VID not configured
Untagged packet, VID configured
Tagged packet with valid VID
Tagged packet with null (0) VID
Access port rules for outgoing packets (Case and Action)
Tagged packet with configured and
allowed VID
Packet from Fluidmesh device
Tagged packet, port VID not configured
Tagged packet with valid but disallowed
VID
Tagged packet with null (0) VID
Access port rules for incoming packets with unit in Smart Mode (Case and
Action)
Untagged packet
Tagged packet (any VID, no checks)
Access port rules for outgoing packets with unit in Smart Mode (Case and
Action)
Packets originating from Fluidmesh
devices (for example: FM Racer
interface)
Signalling traffic
Tagged with valid VID (1 – 4095), not
NVID
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Default value
1
1
Enabled
Smart
Ethernet protocol type $8847 or $09xx
All other traffic
Packet passed
Packet passed
Packet passed
Packet tagged with specified VID
Packet dropped
Packet dropped
Packet passed
Packet passed
Packet passed
Packet dropped
Packet dropped
If native VLAN = ON: Packet passed
(tagged with NVID)
If native VLAN = OFF: Packet dropped
Packet passed with original tag
Packet implicitly tagged with MVID, next
rules apply
Packet implicitly tagged with MVID, next
rules apply
Packet passed (tagged)
Page 79 of 132