Table of Contents
Advertisement
• A graph that reports average signal strength over the last
30 strength-sampling periods.
• A bar that reports the quality of the signal currently being
detected at the local unit receiver.
5.
Do the physical antenna alignment by manually adjusting the
location and direction of the relevant antenna. During the
alignment, use the graph and bar readings to monitor variations
in signal strength.
6.
To increase the readability of the average signal strength graph,
click-and-drag the Zoom x slider.
7.
When the antenna alignment is complete, click the Close button.
• The antenna alignment and stats tool will be closed.
7.5. Network control
7.5.1. Ping softdog
The PING SOFTDOG window contains controls to set up a constant
series of pings to one or more IP addresses.
If connectivity is lost between the unit and any of the saved IP addresses,
an option can also be set to automatically reboot the Cisco FM Ponte kit.
TIP
As well as being a fail-safe mechanism to monitor network
connectivity, the constant ping can also be used as a 'keep-
alive' message to devices that need uninterrupted connectivity,
such as VoIP telephones.
To use the constant ping and automatic reboot functions, do the following
steps:
1.
Click the -ping softdog link under NETWORK CONTROL in the
left-hand settings menu.
• The PING SOFTDOG dialog will be shown
(page
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
52)).
(Figure 22
Page 51 of 132
- Quick Links:
- Unit Configuration
Hide quick links:
Advertisement
Table of Contents
