Table of Contents
Advertisement
Installation Overview
• Power-over-Ethernet (PoE)
The AP can be powered via the PoE input from an inline power injector or a suitably powered switch port.
Depending on the configuration and regulatory domain, the required power for full operation is 802.3bt or
UPOE.
For more information, see
Power Feature Matrix
The following table provides the AP power feature matrix.
Table 8: Cisco Catalyst IW9167I Heavy Duty Access Point Power Feature Matrix
Power
Input
24-48V
802.3bt/
UPOE
802.3at
Connecting a Power Injector
The AP supports the following power injectors:
Table 9: Supporting Power Injectors
Power Source
AIR-PWRINJ-60RGD1=
AIR-PWRINJ-60RGD2=
IW-PWRINJ-60RGDMG=
The power injector provides DC voltage to the AP over the Ethernet cable and supports a total end-to-end
Ethernet cable length of 100 m (328 ft) from the switch to the AP.
When an optional power injector powers your AP, follow these steps to complete the installation:
Step 1
Before applying PoE to the AP, ensure that the AP is grounded (see
Step 2
Connect a CAT5e or better Ethernet cable from your wired LAN network to the power injector.
Warning
To reduce the risk of fire, use only No. 24 AWG or larger telecommunication line cord. Statement 1023
Note
The installer is responsible for ensuring that powering the AP from this type of power injector is allowed by
local and/or national safety and telecommunications equipment standards.
Power Sources, on page
2.4 GHz
dBm Per
5 GHz
Radio
Path
Radio
4x4
24
4x4
4x4
24
4x4
2x2
23
2x2
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
5.
dBm Per
6 GHz
dBm Per
Path
Radio
Path
24
4x4
24
24
4x4
17
23
2x2
17
Description
60W rated outdoor power injector, with North
America AC plug
60W rated outdoor power injector, global version
without AC plug
60W rated outdoor power injector, 5GE
Grounding the Access Point, on page
Power Feature Matrix
Aux
GNSS
mGig
Radio
Eth
Yes
Yes
max 5G
Yes
Yes
max 5G
Yes
Yes
max 1G
33).
SFP
Yes
Yes
Yes/1G
35
Advertisement
Table of Contents
