Table of Contents
Advertisement
User Manual
GFK-1503F
4.3.4
RS-485 Differential Inter-Rack Connection
(IC200CBL601, 602, 615)
Figure 28
4.3.5
Building a Custom Expansion Cable
Custom expansion cables can be built using Connector Kit IC200ACC202, Crimper AMP
90800-1, and Belden 8138, Manhattan/CDT M2483, Alpha 3498C, or equivalent AWG #28
(0.089mm
4.3.6
Connecting the Expansion Cable: Single-ended
For a system with one non-isolated expansion rack (IC200ERM002) and NO Expansion
Transmitter, connect the expansion cable from the serial port on the VersaMax CPU to the
Expansion Receiver as shown below. The maximum cable length is one meter. Cables
cannot be fabricated for this type of installation; cable IC200CBL600 must be ordered
separately.
Figure 29
No Terminator Plug is needed in a single-ended installation; however, it will not impede
system operation if installed.
Installation
2
) cable.
Chapter 4
Jan 2020
36
Advertisement
Table of Contents
