Table of Contents
Advertisement
Chapter 3 Use Your Product
Introduction to Different Operation Tools
3.1
The MSP329 RX/TX allow you to use the front panel link DIP switch, PC configurator, VisualM and IP
controller to manage and control the encoders and decoders. This section briefly introduces how to
route the video from source to the display using these tools. By default, audio, video together with
IR, and USB signals are routed as a whole.
The following tables describes how audio, video together with IR, and USB signals are routed using
all the different tools.
Operation Tools
Description
Link DIP switch
PC configurator
Route audio, video together with IR, and USB signals as a whole.
VisualM
Both of the following routing policies are available.
IP controller
Note:
Operation tools PC configurator, VisualM and IP controller take priority over the link DIP switch.
Link relationship between encoder and decoder performed by the DIP switch can be changed
using any other tools.
When audio, video together with IR, and USB signals are routed via PC configurator, VisualM
and IP controller, press and hold the rear panel RESET button in decoder for less than five
seconds to remove the current link relationship between encoder and decoder, reverting to the
link relationship set by the link DIP switch.
When audio, video together with IR, and USB signals are routed separately via IP controller's
API commands, they can be routed as a whole with other operation tools.
MSP329
Route audio, video together with IR, and USB signals as a whole.
Route audio, video together with IR, and USB signals separately via IP
controller's API commands.
User Manual
14
Advertisement
Table of Contents
