Table of Contents
Advertisement
No.
Name
10
Reset Button
(Recessed)
11
Power Input
MSP329 RX
No.
Name
1
IR Output
IR Input
2
3
AV Output
Serial
4
Communication
MSP329
Description
the RJ-45 port, eliminating the need for a nearby power outlet.
Power supply via a power adapter has higher priority as compared
to PoE power supply. When the device is connected to both the
supplied power adapter and the PoE-enabled Ethernet switch, it
receives power from the power adapter instead of the switch.
RESET: use this button to reset device.
When MSP329 TX is powered on, use a pointed stylus to hold down the
RESET button for five or more seconds, and then release it, it will reboot
and restore to its factory defaults.
Note:
When the settings are restored, your custom data is lost. Therefore,
exercise caution when using the RESET button.
DC 12V: connect this port to the supplied
12 V 1 A power adapter.
Description
IR OUT: connect this 3.5 mm tip-sleeve port to an IR emitter for IR
communication with an IR receiver in the MSP329 TX side on the
network.
IR IN: connect this 3.5 mm tip-ring-sleeve port to an IR receiver for IR
communication with an IR emitter in the MSP329 TX side on the
network.
HDMI OUT: connect this port to an HDMI display device.
RS232: use this port to perform bi-directional serial communication and
device debug functions.
When the front panel "MODE" switch is moved to the "NORMAL"
position, connect this port to a RS232 device such as a computer to
bi-directionally communicate with a RS232 device at the IP controller
side.
When the front panel "MODE" switch is toggled to the "DEBUG"
position, connect this port to a RS232 device such as a computer for
debugging MSP329 RX.
User Manual
10
Advertisement
Table of Contents
