Table of Contents
Advertisement
No.
Name
Communication
7
Audio Output
8
Audio Input
9
IP Stream Output
MSP329
Description
device debug functions.
When the front panel "MODE" switch is moved to the "NORMAL"
position, connect this port to a RS232 device such as a computer to
bi-directionally communicate with a RS232 device at the IP
controller side.
When the front panel "MODE" switch is toggled to the "DEBUG"
position, connect this port to a RS232 device such as a computer for
debugging MSP329 TX.
AUDIO OUT: connect this 3.5 mm stereo tip-ring-sleeve port to an audio
output device such as a speaker and amplifier to output unbalanced,
stereo audio signals.
AUDIO IN: connect this 3.5 mm stereo tip-ring-sleeve port to an audio
input device such as a computer to accept unbalanced, stereo audio
signals.
TRS Connector
Note:
Note:
When this audio port is connected to an audio input device, both
encoder and decoder will output the audio device's audio signals
instead of that from the HDMI video source. If this audio port is
connected via an audio cable but no audio signals are input, you
can get picture but no sound. The situations above do not apply
to the HDMI loop-through port in encoder, which can still output
the AV signals from the video source.
LAN (POE): 10/100/1000 Base-T port, connect this port to a gigabit
Ethernet switch for IP stream output, device control and device
management.
Default protocol:
IP address:
Subnet mask:
DHCP:
Auto-IP:
Link speed
and duplex level:
RJ-45 port LEDs:
Link LED (Left): This green LED lights to indicate a good
network connection.
Activity LED (Right): This yellow LED blinks to indicate
network activity.
Note:
For both encoder and decoder,
Each device can be powered by a PoE-enabled Ethernet switch via
User Manual
This connector illustration applies to both
analog audio input and output in MSP329
TX and MSP329 RX
169.254.x.x
255.255.0.0
Off
On (Default)
Auto-detected
9
Advertisement
Table of Contents
