Height Adjustment Front Fork Attachment; Angle Adjustment Front Fork Attachment - Etac Cross 6 Manual

Height adjustment front fork attachment

Loosen the screws (A and B). Set the desired seat height by measuring
from the floor to the top of the seat post (push down the post in the
cup when measuring) and tighten the screws on one of the front fork
attachments. Use the bar markings as a reference for height adjust-
ment of the opposite side. Tighten the other attachment. Check and
adjust so that the attachmnets are vertical (see section "Angle adjust-
ment of front fork attachment"). Fine-tune the height of the front fork
attachments so that both wheels are on the floor.
A
B
Angle setting front fork attachment
Correct angle setting is important for the wheelchair's driving
characteristics.
Loosen the retaining screw (A) about 2 turns so that the shaft (C)
moves freely inside the sleeve.
Insert the Allen key into the hole (B) and turn until the attachment is
vertical. Always start from a position so that the wheel moves forward
in rotation (D).
Push in the sleeve and hold in the correct position while tightening
the retaining screw.
B
A
12. Advanced settings, customization
6 mm
20Nm
Consider the risk of tipping.
Always check the setting of the anti-tip guard.
Consider the risk of tipping.
Always check the setting of the anti-tip guard.
Aim for something vertical, such as door post, table legs when
setting.
C
21
Etac / Cross 6 / www.etac.com
20Nm
6 mm
D
VIDEO
VIDEO