Settings; Front Seat Height; Seat Height Adjustment Using Front Fork Attachment; Seat Height Adjustment Using The Castor Wheel's Position In The Fork - Etac Crissy Series Manual

Etac / Crissy / www.etac.com
Front seat height is adjustable using:
- Front fork attachment, adjustable height and
angle
-Changing height in front fork.
-Changing front fork
-Changing castor wheels
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.

Seat height adjustment using front fork attachment

Loosen the screws (A and B) on both castor wheel
attachments. Set the desired seat height by measur-
ing from the floor to the top edge of the seat frame
(press down the frame in the cup while measuring)
and tighten the upper screw (B) on one front fork
attachment. Adjust so that the attachment is perpen-
dicular. (See ‚Angle setting of front fork attachment'
section.) Tighten the lower screw (A). Repeat the
B
A
Seat height adjustment using the castor wheels' position in the fork
See also section "Front seat height table".
5 mm

6. Settings

Front seat height

procedure for the other attachment. Fine-tune the
height of the front fork attachments by loosening
the screws a little and carefully knocking on the front
fork attachment. Make sure both castor wheels are
touching the ground. Tighten the screws.
± 1,5 cm
12
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
6 mm
20Nm