Disassemble/Assemble The Front Fork; Disassemble/Assemble The Castor Wheels - Etac Xact User Manual

Etac / Xact / www.etac.com

Disassemble/assemble the front fork

- Loosen the screw (A) and remove the cover plug
(B) Loosen the retaining nut (C), pull out the
front fork and transfer the chamfered washer
(D) and the ball bearing to the new fork.
- Fit washers and ball bearings in the front
fork attachment as shown in the illustration.
Place washer (D) with the chamfered side
facing the fork. Spring washer (E) at the top
under retaining nut.

Disassemble/assemble the castor wheels

Loosen screw, nut and spacers and mount
the wheel in a suitable position.
11. Advanced settings, adjustments
A
B
C
- Tighten the retaining nut carefully until the
front fork turns with some inertia, and then
loosen approx. 1/2 turn. This gives the spring
washer the correct tension, which reduces the
risk of the castor wheel starting to "wobble".
- Fit the cover plug.
E
D
Make sure that the small pin of the plastic spacer
locks into the appropriate hole in the fork.
5 mm
12,5 mm
12,5 mm
12,5 mm
24
5 mm
19 mm
VIDEO VIDEO VIDEO
VIDEO
VIDEO