Table of Contents
Advertisement
Etac / Prio / www.etac.com
Height adjustment, front, by replacing the front fork/castor wheel
See section "Height adjustment, front, using the castor wheel position in
the front" and "Seat height table".
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Forward height adjustment using front fork attachment
With a 6.5" castor wheel, the front fork mounting must be height-
adjusted in certain rear wheel positions. Loosen the screw that holds
the front fork mounting and adjust the height so that the lower tube
of the chassis is parallel to the floor.
Tighten the screw again.
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
Disassembly/assembly of the front fork
1. Remove the nut cover and disassemble/assemble the front fork with
the castor wheel in accordance with the illustration.
NB! It is important to ensure that the ball bearings and washers in the
attachment (under the retaining nut) are placed in the right order with
the spring washer on top.
During installation, tighten the retaining nut until it comes to a stop
and then release by ½ – 1 turn. The spring washer then has the correct
tension and reduces the risk of the castor starting to "wobble".
7. Settings
Bear in mind the risk of tipping.
Always check the positioning of the anti-tips.
19 mm
16
5 mm
19 mm
6 mm
20 Nm
Advertisement
Table of Contents
